7/24/2023 0 Comments Fortigate 60e![]() ![]() ![]() You can force the duplex/speed on internal1 by using:Ĭonfig system interface edit "internal1" set speed 1000full next end If duplex/speed is set, it should show up as " set speed ". Use show full system interface internal1 to display the full configuration on internal1. Use show system interface internal1 to see how the internal1 port is configured. (This is assuming you have something plugged into that interface port.) If there are errors, wait 2-3 mins then repeat the diag commands to see if the error counts increases. What you are looking for is the duplex/speed value and any rx/tx errors or any errors for that matter. Output should be something similar to the following.ĭescription Fortinet 92D Ethernet Driver System_Device_Name internal1 Current_HWaddr 90:6c:ac:00:00:00 Permanent_HWaddr 90:6c:ac:00:00:00 State up Link up PHY Link up Speed 1000 Duplex full port: 0 def vid 4094 cur_vid 4094 netdev_running 1 pci_rx 0 Rx_Packets 341499 Tx_Packets 615994 Rx_Bytes 58315364 Tx_Bytes 220265980 You can perform a diag on the interface from the CLI using diag hardware deviceinfo nic Įg.
0 Comments
Leave a Reply. |